Konversi Limbah Plastik Kampus IPB Darmaga Menjadi Paving Block dan Pot Tanaman
Date
2022-07Author
Desyani, Noor A'fiana
Yuwono, Arief Sabdo
Putra, Heriansyah
Metadata
Show full item recordAbstract
Upaya yang dapat dilakukan untuk mengurangi dampak buruk limbah
plastik adalah daur ulang (recycle) plastik menjadi produk baru. Penelitian ini
bertujuan melakukan identifikasi dan karakterisasi limbah anorganik di Kampus
IPB Darmaga, merancang bangun dan melakukan uji unjuk kerja alat peleleh
limbah plastik, dan mengolah limbah plastik menjadi paving block dan pot
tanaman. Identifikasi dan karakterisasi dilakukan terhadap sampah anorganik di
Kampus IPB Darmaga dengan fraksi terbesar adalah sampah plastik campur
mencapai 36,13%. Berat jenis sampah plastik campur adalah 0,0112 kg/L. Alat
peleleh plastik dirancang dengan kapasitas 12 kg. Alat peleleh plastik terdiri atas
kerangka meja dan ruang pelelehan berbentuk tabung tertutup. Alat tersebut
terbuat dari material besi, dilengkapi dengan termometer dan pipa keluaran. Uji
unjuk kerja memperlihatkan bahwa alat sudah berfungsi dengan baik. Titik leleh
plastik tercapai pada suhu 180 0C. Plastik yang sudah meleleh dapat dibuat
menjadi pot tanaman maupun digunakan sebagai bahan tambahan paving block. The solution that can be done to reduce the bad impact of plastic waste is
to recycle plastic into new products. This study aimed to identify and characterize
inorganic waste at the IPB Darmaga Campus, to design and test the performance
of a plastic waste melting device, and to process plastic waste into paving blocks
and plant pots. Identification and characterization were carried out on inorganic
waste at the IPB Darmaga Campus and it was found that the largest fraction was
mixed plastic waste, reaching 36,13%. The density of mixed plastic waste
measured was 0,0112 kg/L. The plastic melter is designed with a capacity of 12
kg. The plastic melter consists of a table frame and a closed tubular melting
chamber. The tool is made of iron material, equipped with a thermometer and
output pipe. The performance test showed that the tool is functioning properly.
The melting point of plastic is reached at 180 0C. Melted plastic can used to make
plant pots or used as additional material for paving blocks.