Extraction of oil from jatropha seeds using a twin-screw extruder: Feasibility study
Abstract
The objective of this study was to evaluate the feasibility of mechanical pressing to extract oil from jatropha
seeds using a twin-screw extruder. Experiments were conducted using a co-rotating (Clextral BC
21. France) [Win-screw extruder. The influence of operating conditions on oil yield. specific mechanical
energy and oil quality was examined. Operating conditions included screw configuration. pressing
temperature and screw rotation speed.
Generally. it was the screw configuration. or profile. that most affected oil extraction efficiency. The
best oil yields. a minimum 57.5%. were obtained with a trituration zone composed of 10 monolobe and
10 bilobe paddles. and a preSSing zone composed of SOmm long. reverse pitch screws with a - 33 mm
pitch. In addition, oil extraction yield increased with decreasing temperature and screw rotation speed.
Highest oil extraction yield (70.6%) with good press cake qualicy (residual oil content lower than 8%) was
obtained under operating conditions of153 rpm screw rotation speed. 5.16 kg/h inlet flow rate of jatropha
seeds. and 80 0
( pressing temperature. The corresponding expressed oil was inexpensive to produce
(71 Whlkg seed processed or 314Wh/kg expressed oil for specific mechanical energy) compared with
another continuous technique. i.e. the single expeller press. commonly used for mecha nical extraction
of jatropha oi l. Its quality was also satisfactory for biodiesel production. The acid vo1 lue. the density and
the kinematic viscosity were 5.4 mg o( KOHlg o( oil. 915 kg/ml and 36.7 x 10- 6 m2Js. respectively